repairing cat 5 cable

repairing cat 5 cable:

If you lose your internet connection and do not want to find the problem, check your skin before wear and tear. If you think the Ethernet cable is damaged or split, this guide will allow you to repair the cable so you do not have to buy the next one.

• Decide where the wire needs to be repaired. If the removal of the area makes the cable shorter, consider adding an extra extension to make it longer. In some cases, it may be more useful than just buying a new cable.
• Clear it. If the wire has a shortened area, cut off the area.
• Determine the method used to control small wires (usually 22-28 AWG). Use a method that suits you. As long as your poisoning is developing, it should work.
• Insert the sheet of paper you want to be larger than the item you want to fold. These tubes can be very long, but usually, 2-6 inches would be appropriate. The length depends on the pressure mode.
• Take the drive cable of your choice and cut the coverage area of ​​the appropriate length for the lighting technology from the two cables. If a sheet of metal is in this area, you can remove it. Do not cut or unplug 8 small wires undercover.
• If the yarn is made of cotton or linen-like fabric, you can also remove them. This is a thread insertion.
• Install an attractive tube for each row, approx. Three times the length of the cut, on one side of the cut. The table should be large enough to cross the gap made, but it will not be large enough not to move the size of the wire used.
• Use a single piece of wire to remove the wire of the appropriate length for the welding process from each of the 8 wires. Perform this procedure on two wires (you need to remove a total of 16 wires).
• Make a difference on each wire. Will separate the orange wire on one side of the cable into the orange wire on the other side of the cable; orange / white wire on one side of the orange / white wire on the other end of the wire; and continue with eight different colored yarns.
• Avoid over-selling because the wires are fragile and may cause them to fall off later.
• Using a multimeter, measure the resistance on each Ethernet cable. To do this, attach the wire at both ends of the wire to the same wire. If the resistance is more than 3 ohms for a cable over 30 meters, try stopping again. If you are reading open (O.L. with several ohmmeters), make sure the correct cables are connected. If you are sure you are using the correct cable and you still have the cable open, the cable may be defective and replace the Ethernet cable.
• Transfer a small amount of heat to a small tube in each of the 8 incisions. It is necessary for the hose to fit and tighten the cover on both sides at the end. Use firearms to cut the pipes completely. When they fall completely, you can not move them with any wire.
• Hold a large oven on all 8 wires. All 8 mesh pipes must be installed so that both ends extend beyond the hose cover. Wipe the lid completely with wires.
• Try your Ethernet! You can push the end of each test or try using the cable as a power cord to check performance. If this works, repair the Ethernet cable properly.